"); //-->
28V 线性充电 ZCC3221替代CE3221
INTRODUCTION :
The ZCC3221 is a complete constant-current/ constant-voltage linear charger for single cell lithium rechargeable battery. No external sense resistor is needed, and no blocking diode is required due to the internal P-MOSFET architecture. Furthermore, the ZCC3221 is specifically designed to work with in USB power specifications. Its low external component count makes the ZCC3221 ideally suited for portable applications. Thermal feedback regulates the charge current to limit their temperature during high power operation or high ambient temperature. The charge current can be programmed externally with a single resistor. The ZCC3221 automatically terminates the charge cycle when the charge current drops to 1/10ththe programmed value after the final float voltage is reached. When the input supply (wall adapter or USB supply) is removed, the ZCC3221 automatically enters a low power sleep mode, dropping the battery drain current to less than 2mA.The ZCC3221 can be put into shutdown mode, reducing the supply current to 50mA.Other features include battery pack temperature monitor, under voltage lockout, automatic recharge and two status pins to indicate charging and charge termination.
FEATURES:
l Charges Single Cell Lithium Battery Directly from USB Port or ACAdapter
l Input VoltageRangeFrom 4.5V to24V
l InputOVP:6.5V
l No External MOSFET, Sense Resistor or Blocking DiodeRequired
l Preset4.20V/4.35VChargeVoltage
l Continuous Programmable Charge Current Up to1.2A
l Recharge Conditioning for Reviving Deeply Discharged Cells and Minimizing Heat Dissipation during Initial Stage ofCharge
l Constant-Current/Constant- Voltage/Constant-Temp Operation with ThermalRegulationtoMaximizeChargeRate Without Risk ofOverheating
l Battery ReverseProtection
l AutomaticRecharge
l Battery TemperatureSensing
l Charge state pairs of output, no battery and fault statusdisplay
l Charge Current Monitor Output for Gas Gauging
l Automatic Low Power Sleep Mode When Input Supply Voltage isRemoved
l Soft-Start Limits InrushCurrent
l Chip Enable Input
专栏文章内容及配图由作者撰写发布,仅供工程师学习之用,如有侵权或者其他违规问题,请联系本站处理。 联系我们
相关推荐
移动电源9V叠层电池终结者二号:单节升压型锂电池代替9V或15V叠层电池
【解决方案】一颗IC芯片从单节锂离子电池产生三个低于2V的电源轨
600mA单节锂电池充电电路
单节锂离子电池保护芯片的设计
恒流/恒压单节锂离子电池充电器芯片—XC6801
单节锂电池供电的简单方案
用LTC732作为控制器为单节4.2伏锂离子电池充电
AICl811组成的单节锂离子电池保护电路
单节Li +底座与线性AC适配器充电器
单节锂电池供电的高效率白色LED驱动电路图
一种单节锂电池保护IC设计
MAXl898单节Li 电池线性充电器
单节/双节锂电池专用充电芯片HT6292
为什么锂电池单节保护板不可以串联多节使用